东莞移印机(5) Testing the printer parts

  Product quality is highly related to operational condition of the parts, to lengthen the working life of the printer,

pre-operational check is very important:

A) Plug in and turn on the power switch, check the cycle counter (Appendix a, 4) is it shows 0000 or 00000, if any number is

  shown, it means the printer cannot be operated at the moment. Check the circuit connection.

  The number tells that there is error among the 4 printing sensors, it may be caused by the damage of sensors or the sliding

  guide is not staying at the sleeping position.

  Conduct the sensor damage test, cut off the air pressure first, put the masks at the centre of sensors at(2)&(3)(Appendix 12),

  then turn on the power supply. The cycle counter will show 00 20 or 00020, then push the sliding guide gradually so that the

  mask block out (1], (3), (a) sensors respectively, the relative number will flash, if it does not flash, it means that sensor is

damaged, lastly slide back to (2) sensor position. The cycle counter will show 0000 or 00000, it means the 4 sensors are at

normal operation. Other tests can be followed.

东莞移印机B) Press the printing unit forward/backward moving button (Appendix a, 7), check the moving is smooth without any alien sound.

C) Press the pad up moving button(Appendix 4, 8), check the moving is it normal? Is the lifting position required adjustment, any

  alien sound.

D) Press the auxiliary button(Appendix 4, 5), check the shuttle device or the conveyor movement relative to the pace of sliding

  and pad lifting, any alien sound.

6)Adjusting the dr.blade upward/downward valve (Appendix 16,17, 18)

7) Shock absorber manual

  Adjusting the shock absorber in best working condition. (Appendix 19)东莞移印机

东莞恒晖彩印机械厂有限公司，主营产品：东莞移印机、东莞丝印机、东莞热转印机